| Book |
Page |
Context |
 |
 |
Figure 5c NOTE Between both leads and the terminal ADJUSTING REGULATOR VOLTAGE 8 Run engine at 1500 rpm or above for at least 15 minutes of warm up then cycle regulator voltage control by disconnecting ...
okay If voltage is not within 13 5 to 15 2 volts leave engine running at 1500 rpm or above and a Disconnect four terminal connector and remove regulator cover Then re connect four terminal ...
Disconnect four terminal connector and reinstall regulator cover then reinstall connector c Continue running engine at 1500 rpm for 5 10 minutes to re establish regulator internal temperature d Cycle regulator voltage by disconnecting |
|
 |
Lamp Circuit test before continuing test 5 If lamp glows start the engine and run it at 1500 rpm or above Check indicator lamp If lamp fails to go out perform appropriate test and corrections ...
Turn on high beam headlights and heater blower motor to high speed run engine at or above 1500 rpm for h few minutes if necessary and read the voltage on meter NOTE Voltage will |
|
 |
regulator No 2 terminal to ground fig lOc 2 Operate the engine at fast idle 1500 to 2000 rpm and observe voltmeter reading 3 If voltmeter shows zero voltage at regulator check circuit between |
|
 |
point worn rubbing block or worn dis tributor cam 2 Check dwell variation Slowly accelerate engine to 1500 rpm and not dwell reading Return engine to idle and note dwell reading If dwell variation exceeds |
|
 |
belt was installed run belt in at 1500 rpm for at least two minutes then recheck deflection NOTE If a strand tension gauge is not available adjust belt to give a 3 8 deflection between |