secure it with set screw 6 Attach connectors to rear of switch as shown in Figure 8 109 and test operation of wipers and washers NOTE The washer connector is the lead that
| Book | Page | Context |
|---|---|---|
|
|
used on units without windshield washers Two connectors are used on units with windshield washers fig 8 109 2 Remove the small set screw from bottom of wiper knob and remove knob 3 Remove attaching ... secure it with set screw 6 Attach connectors to rear of switch as shown in Figure 8 109 and test operation of wipers and washers NOTE The washer connector is the lead that |
|
|
hinge from body 3 Remove screws securing heat exchanger opening cover to floor pan supports fig 10 109 and remove cover assembly from body 4 To install reverse removal procedure ENGINE COMPARTMENT COVER PANEL ASSEMBLY |
|
|
WITHOUT WASHERS TRIM PLATE WIPER II CONNECTOR WINDSHIELD WASHER CONNECTOR SWITCH USED WITH OPTIONAL WASHERS Fig 8 109 Windshield Wiper Switch Installation assembly and loosely install the two attaching screws Install the retainer onto |
|
|
Figure 6A 100 Install pickup tube retaining clamp to tube and crankcase as shown in Figure 6A 109 29 Coat threads on engine temperature and oil pressure sending units with anti seize compound such |