RS PQQ NEUTRA Fig 61 2 Shift Linkage Check Diagram the transmission fluid to warm up 2 With engine at normal idle speed then very slowly move the range selector lever up from N toward R and note by feel the point at which the reverse clutch applies Properly adjusted the reverse clutch should apply within the band from the tooth peak to full Reverse detent fig 6E 2 3 Make the same check as in step 2 above while moving the selector lever from N toward D Properly adjusted the low band should apply as the selector lever follower is felt to be between the tooth peak separating Neutral from Drive and full Drive detent 4 Unless the shifts are obtained at the points illustrated in Figure 6E 2 the shift linkage should be adjusted with gauge J 8365 Adiustment Adjustment of the manual valve linkage should be checked after any transmission overhaul or control cable or range selector control assembly replacement as described below MA rvvw 1 8365 VALVE L K SCREW n 1i 3 A44wtMq Monvol Volvo Linkage with J4365 1 If necessary drain oil from transmission by unscrewing filler tube nut then remove oil pan 2 Place the range selector lever in the driving compartment in D Drive 3 Insert J 8365 into manual valve bore as shown Fig 6E 3 with tab of gauge upward so it engages to forward port of the valve body as shown in the inset Figure 6E 3 4 With J 8365 in place push forward on the manual valve levers as shown Properly adjusted J 8365 will be held in place horizontally without being supported 5 If readjustment is required loosen lock screw fig 6E 3 push the manual valve levers forward so that J 8365 is held in this attitude Recheck adjustment as described in Step 4 6 When satisfactory adjustment is obtained install oil pan and filler tube then refill transmission with oil as described earlier in this section NEUTRAL SAFETY SWITCH ADJUSTMENT Properly adjusted the neutral safety switch fig 6E 4 should prevent engine cranking when the ignition switch is turned to Start with the transmission selector lever in any position other than N Neutral If engine cranks with selector lever in a position other than N adjust the switch position by loosening the two switch mounting screws placing the range selector in Neutral and turning the ignition switch to START Shift the switch fore and aft until engine cranking begins then secure switch in that position 7 u R N D t RI 61 4 N utral Safety Switch THROTTLE VALVE LINKAGE ADJUSTMENT Correct throttle valve TV linkage adjustment is necessary to provide the correct shift schedule