I y 34 SYNC 3rd GEAR A w t REAR BEARING 1 RETAINER k I st GEAR q W Fig 6D 39 tomoving 1 2 Synchronizer and First Goof Sleeve from Mainshaft INSPECTION AND REPAIR Wash the transmission case inside and out with a Transmission Case rear face which fits against ifferential carrier for burrs and if any are present dress them off with a Also check the condition of the shifter shaft seal and replace if necessary 1 Wash the front and rear bearings thoroughly in a cleaning solvent 2 Blow out bearings with compressed air CAUTION Do not allow the bearings to spin 3 Make sure the bearings are clean then lubricate them with light engine oil and check them for roughness Roughness may be determined by slowly turning the outer race by hand All clutch gear and countergear bearing rollers should be inspected closely and replaced if worn Inspect countershaft at the same time and replace if necessary Replace all worn spacers Inspect fine mill file Front and Rear Bearings but turn them slowly by hand Spinning bearings will damage the race and balls Bearing Rollers and Spacers Gears and Thrust Washers sary replace all that are worn or damaged Clutch Keys and Springs