FOLDING TOP ll 25 weatherstrip and rear quarter window then b Loosen male hinge assembly attaching bolts tighten bolts Fig l158 d Lock front roof rail to windshield where r Without changnig tore and alt location of male required adjust front roof rail as previously hinge adjust male hinge up or down as required described and cheek fit of top material at rear to obtain proper alignment between side root quarter trim stirk area It necessary adjust rails and rear quarter windows trim stick then tighten trim stiek attaching bolts d Tighten attaching bolts while maintaining e Cheek top assembly for proper stack height proper alignment of vertical seribe marks and proper alignment of side root rails over door and quarter windows Where required ad e Cheek fit of top material at rear quarter trim just control link adjusting plate as previously stiek area and if necessary adjust trim stiek described See steps til and 2 under Adjust If adjustment is not necessary tighten trim ment of Top Control Link Adjusting Plate stick attaching bolts NOTE li top uannot be fully raised or lowered f Cheek top assembly for proper stack height even after Control link plate has been adjusted and proper alignment of side roof rails over re adjust male hinge assembly as required door and quarter windows Where required ad Cheek top for proper operation just control link adjusting plate as previously described See steps Ml and 2 under Adjust 2 If side roof rail is too high or too low at rear ment ol Top Control Link Adjusting Plate quarter window area proceed as follows NOTE lf top cannot be fully raised or lowered a Mark location of male hinge attaching bolt even after control link plate has been adjusted washers and Control link on folding top com re adjust male hinge assembly as required partnient braee Cheek top for proper operation