1 V 1 Lz r J r 3 1 L Y 1 1 1 EMBLEM 1ZNS I AL A Q ANI E l m PEOCEDURES 1 1 BODY AND EMBLEM OR SCRIPT PREPARATION 3 ADHESXON TEST REQUIREMENT 1 A Clean ai ea of body surface where emblem or scripts are to be A Emblems or scripts shall not exhibit any evidence of bond failure applied maximum of Biree 3 job lengths prior to emblem or when subjected to the following force applied normal tc emblem script installation with n suitable solvent 9981293 isopropyl mounting surface alcohol 50 50 mixture by volume with water 9981062 high Part No Pounds 1 flash naptba or equivalent Use clean cloth change 379918 35 1 f every 2 h S Emblem or sariggeesgj c be conducted at an ambient tempo anne 1 1 B Dry surface with clean cloth replace cloth minimum of every giigotegcgziiegobel iv and B I 3 mmmmm Of mc 12 hours agmg 1 two 2 hours Care should be taken to insure there is no D 1 surface re contamination previous to emblem or script 1 installation B Emblem or script must be uniformly bonded for entire length 1 l C Emblems or scripts are to be removed from cartons and placed nots Any section oi emblem or script removed aiter once on heat table adhesive side to heat in contact with the bodv surface must not be reused See 1 data drawing 1740857 for approved repair procedure 1 D Body and part temperature at time of emblem or scripts 1 application must be 80 F 2600 minimum or l0 above the 1 air temperature in the application area whichever is higher 1 1 1 105 40 C maximum Part must be uniformly heated to 1 insure that both body surface and emblem or scripts are free 1 of moisture during installation 1 Z EMBLEM OR SCRIPT APPLICATION TO BODY Q J A Load emblem or scripts in fixture and remove protective liner immediately prior to installation in an atmosphere tree Q 1 of obvious contaminants dirt dust adhesive sprays fibers 9 1 etc Adhesive surface must not be touched or brought in I contact with any surface or foreign matter B Apply the emblem or script to the body surface and clamp to obtain 015 38 him minimum compression of foam tape for 1 bonding maintaining the temperature and cleanliness 1 requirements as previously described n1 uu 1 1 1 1 I uu 11 1 i 1 f1 1 Q noi T S v T TE rr 464887 1 gv MBE r e wes wars may M1 wu my COR ET Y 1 J 1 1 EMBLEM INSTALLATION AND 1 5 L 1 TESTING PROCEDURES Q L 1 1 w2 Llwggw 1 4 A 1 Ts 1 se e 1ca5 57 S 11 1 rv 1 1 1 T 1 t Q Z1 171i L 1 I il 1 ji 1