d I Fig 3 15 installing Sphorical Joint 3 Press joint assembly into arm until shoulder contacts arm flange 4 Set control arm in place with the stud of the joint up through steering knuckle Install and tighten nut Install cotter key Removal of Control Arm Bushings 11 To remove the bushing set up the tools as shown in Figure 3 16 The bushing may be pressed or hammered out of position In any case be certain to press on the end of the bushing that does not have the large collar on outer shell Installation of Control Arm Bushings 1 If lower control arm bushing was removed replace as shown in Figure 3 16 The bushing must enter the control arm on the front side of arms Installation of Control Arm and Spherical Joint REMOVING J 7079 2 S J 8346 2 o 00 J 8346 1 J S888 3 Fly 1 16 Removing and Intt N J l1 AI i I r Fig 3 17 Front Coil Spring Installation Hoist Installation of Front Coil Spring 2 Place spring on control arm 3 Rotate spring until upper end of coil makes contact with its seat 4 Using either the front post fig 3 17 or a jack stand fig 3 18 raise control arm line up arm and bracket and install bolt from the front nut and lockwasher Do not tighten at this time NOTE A bar placed up through control arms and into spring tower will retain spring and keep it secure until pivot bolt is installed INSTALLING J 7079 2 J 8346 3 346 1 J 5888 3 rlllng lew r Control Arm Bushings