t s 2 56 39 92 4 Reverse the lock cylinders so that the head of the cylinder is now toward you Insert the spring retainer so that one of its six prongs enters into each of the springs and the two large end prongs slide into the slots at either end of the cylinder fig 1 17 Press the retainer down with one finger 5 To check insert proper key and if tumblers are installed properly the side bar will be allowed to drop down If bar does not drop down remove the key spring retainer springs and tumblers and reassemble correctly NOTE If the tumblers have not been assembled correctly and not according to the code the tumblers can be removed from the cylinder by holding it with the tumbler slots down pulling the side bar out with the fingers and jarring the cylinder to shake the tumblers out This procedure is necessary because after the tumblers have been pressed down into the cylinder they are held in their slots by the cross bar 6 If after checking it is found that the lock is assembled properly remove key and place cylinder in a vise using leather or wood on each side to prevent damage to the cylinder 7 Stake the retainer securely in place by staking the cylinder metal over both edges of the retainer ends using a suitable staking tool at right angles 21 32 DIA REAR BUMPER LIFT HOLES i 37 88 4 00 6 6 00 4 0 2 5t D 00SURFACE 58 18 i iURFACE A 15 5 7 34 7 24 41 7 ihlng point diagram