Fig 15 Windshield Wiper Switch Installation NEUTRAL SAFETY SWITCH REPLACEMENT Fig 16 1 Disconnect the battery ground cable 2 Remove instrument cluster assembly from vehicle 3 Remove the retaining ring securing the switch lever arm to range selector assembly 4 Remove the two screws that attach the switch to the range selector assembly 5 Lower the switch and disconnect the wiring harness connectors from the switch terminals 6 Install wiring harness connectors onto new switch 7 Extend plunger in switch to its outer most position and insert gauge block in switch case 8 Position switch plunger pin to the range selector assembly and loosely install the two attaching screws A o VIEW A fig 16 Neutral Safety Switch Installation W OFF ON I 370 Ni NEW A A Fig 17 Backing Lamp Switch 3 Speed Transmission 9 Install the retainer securing the plunger pin to the selector assembly 10 Place transmission range selector into IN neutral position 11 Push forward on switch case until contact carrier is against gauge block 12 Tighten switch attaching screws and remove gauge block 18 Test operation of switch Engine must start in N neutral position only Check operation of backing lamps if so equipped yiHIY A A J o Fig 18 4 Speed Tnonstaision Backing Lamp Switch ffWWO aWu