Service procedures outlined in the 1965 Corvair Chas 2 Measure the following two distances fig 1 sis Shop Manual apply as well to the 1968 Corvair Front a From the floor to the center of the inner pivot Suspension except as described below of the lower control arm b From the floor to the bottom surface of the lower Front Wheel Bearings ball stud assembly Adiushnem 3 The difference between these two measurements is Revise step 2 of 1965 manual on wheel bearing adjust Egethixiilggcatlons gwen m the Speclflcatmn Section mg nut torque to 12 1b ft This applies to 1965 through 4 Measure the opposite side of the vehicle in the same 1968 Cowan V h1C19S manner The measurement for both sides should d ff th lf Lower Control Arm 1 er no more an ha inch Installation When installing the inner pivot cam adjusting bolt the bolt should be tightened to the revised torque reading of 80 lb ft instead of 90 120 lb ft as stated in the 1965 Corvair Chassis Shop Manual 1 E Torque Specifications Refer to specifications in rear of manual for correct torque values L I nl R d ng Helghl Gnd COI SPTIUQ SUQ Q The Corvair Ricling Height procedure has been re G vised from that which appeared in the 1965 manual b 1 Position vehicle on a smooth level floor Vehicle at curb weight a full tank of gasoline but an empty front compartment except for spare tire when in stalled 1IltI UI1k Fig l Cl1ecl ing Riding Height CORVAIR SHOP MANUAL SUPPLEMENT