ENGINE 6 4 ENGINE ASSEMBLIES 2 Align bracket with rear bolt on underside of carrier using drift to align bracket during bolt installation lnsmuunon 3 Install rear bolt on side of carrier then install When connecting the rear strut rod brackets to the mmammg bob to 1 mderslde O Carmel 4 Alternately tighten all bolts in small mcrements to differential carrier during engine installation it is rec ermit an even draw a amst bracket Ti men all ommended that the retaining bolts be installed in the P g g following mama bolts snugly and check bracket for proper seating 1 Using a mug dma angn bracket with dirrerenuai against T rq aub 1tS carrier and install the forward bolt on the side of NOTE It is recommended that the strut rods carrier Do not tighten bolt Remaining bolts will be installed before installing the axle drive require further alignment shafts CORVAIR SHOP MANUAL SUPPLEMENT