WEATHERSTRIP OUTER LIP Fig 10 92a Installing Rear Quarter Window Weatherstrip mallet will enable easier installation of retainer strips BODY SIDE FRONT AND REAR WINDOW Removal 1 Remove window regulator handle set screws and remove both handles and washers fig 10 95a 2 Remove 23 trim panel retaining screws and remove trim panel fig 10 93a 3 Remove two retaining screws at window regulator arm guide rail fig 10 94a 4 Remove guide rail from sash assembly 5 Remove upper weatherstrip seal from window opening fig 10 95a 6 Remode screws A and B fig 10 94a from run channels Remove channels from window assembly and remove window and sash assembly out through window opening 7 Remove glass and lower seal from sash channel Installation 1 Brush inside of sash channel removing all rust and foreign matter 2 Install rubber seal with lip of lower seal towards outside as shown in Figure 10 95a 3 Install window glass in rubber seal and sash channel 4 Hold window assembly with one hand then with the other install window assembly into run chan SIDE WINDOW MOLDING TRIM PANEL 1 I I Fig 10 93a Body Side Front and Rear Window Trim Panel MOUNTING E u S REvVS s f RLiN CHANNEL SCREW S UMPER GUIDE BUMPER SASH RAIL jp ifl I A1 II Fig 10 94a Body Side Front and Rear Window Regulator Assembly nels Install retaining screws in each run channel fig 10 94a 5 Install window upper weatherstrip in window opening weatherstrip has clips attached for installation 6 Install guide rail to regulator arm fig 10 94a and retain with retainer screws 7 Install regulator handle to check operation Remove handle and install trim panel with retaining screws 8 Install both regulator handles and fasten securely with set screws