I To replace a rear door window proceed as follows Replacement I 1 Using a pointed tool raise one end of the weather strip retainer until it is far enough out to take holc of by hand Then pull retainer out of its channe I all around the window 2 From inside the door carefully push the windoa glass out through the rear of the opening NOTE The weatherstrip may remain in the window opening during removal of glass To remove weatherstrip merely pull it off the edges of the door panels On installation of new weatherstrip clean opening edge thoroughly then install with butt ends lightly coated with weatherstrip adhesive at top center of opening r 3 Inspect the door inner and outer flanges makin sure they are true and that there are no irregu larities around the opening Any irregularitie must be corrected 4 Assemble the weatherstrip to the opening makin sure the outer channel of weatherstrip is firml seated on the edges of the door panel all arounl the opening 5 Start one end of the glass into its channel in th weatherstrip Using a pointed tool follow arounl the rear lip of the glass channel so it bears agains the rear surface of the glass NOTE Care should be used in this operation not to chip the edge of the glass A pointed wooden tool if available should be used 6 Feed one end of the weatherstrip retainer into th handle of Tool J 2189 fig 10 89a and out throug the end which spreads the weatherstrip channe Fig 10 89a Weathersirip Retainer Tool J 2189 7 Starting at the bottom center insert the end c the tool and end of retainer in channel tapere part of the retainer toward the glass 8 While holding the tool firmly with spreading en in channel follow around the channel spreadin it open and feeding retainer into the opening unt the full length of the retainer has been fed int the channel fig 10 90a The ends of the retaine should join at the bottom center NOTE Care should be used in this operation not to chip the edge of the glass A pointed wooden tool if available should be used l I I I Fig 10 90a Installing Rear Door Glass Weatherstrip Retainer REAR QUARTER WINDOW REPLACEMENT 1 Raise window weatherstrip edge and remove four s retainer strips two at the bottom and one at each side fig 10 91a NOTE Retainer strips are centered behind tabs on window opening i 2 Remove window and weatherstrip by tipping the bottom edge into the vehicle compartment i t RETAINER STRIP WEATHERSTRIP i l RETAINER STRIP Fig 10 91a Removing Retainer Strips and Weatherstrip 3 Install weatherstrip to glass and butt ends of f weatherstrip with adhesive 3 NOTE Butt joint is installed at top center of window g 4 Install a retainer strip at each side of window I opening positioned behind tabs 5 Install weatherstrip and window assembly With r the aid of a helper holding window in place guide outside lip of weatherstrip in place with Tool J 2189 fig 10 92a 6 Install two retainer strips under weatherstrip against the tabs fig 10 91a A wood punch and CORVAIR SHOP MANUAL