To Aid in Tie in Between the Right and Left Rear Doors Shim between the striker plate and door panel using one or more spacers on the left rear door fig 10 79a REAR DOOR CHECK REPLACEMENT 1 Open rear doors and remove retaining bolts at A fig 10 83a and remove check assembly and retainer plate and dust seal 2 To remove check plate from door remove two retaining screws and remove check plate 3 Install door check plate to door and check assembly with retainer and dust seal Dust seal keeps dust out of door assembly NOTE Door check assembly can be adjusted up and down as shown in Figure 10 83a NOTE Door checks on rear door are not interchangeable with side doors fR TANCS F D WN DOOR HINGE PILLAR Fig 10 83a Rear Door Check Assembly 1 Dust Seal 3 Rubber Guide Roll 2 Check Assembly 4 Retainer Plate REAR DOOR ASSEMBLY Removal 1 Open door and unhook door check 2 Remove plastic plugs from hinge assembly fig 10 84a and remove the door to upper hinge re taining bolts 3 With the aid of an assistant to support weight of door then remove the door to lower hinge retaining bolts and slide door off of hinge and grommet fig 10 84a NOTE Doors can be removed for other reasons than door replacement by removing hinge pins shown in Figure 10 84a DOOR I HINGE EDGE I REINF BOLT HINGE PIN v B a h UP OUT VIFW T GROMMET DOWN 1 A i 1 SPACER GROMMET BUMPER r SCREW PLASTIC BOLT PLUG Fig 10 84a Rear Door Hinge Assembly 4 If hinge is damaged remove the hinge to pillar bolts and remove the hinge fig 10 84a Installation 1 If a hinge has been removed install the hinge in the pillar in approximately the same position as previously installed Assemble grommet to door before inserting hinge in door and bolting 2 Position door and install the retaining bolts just snug until after making door adjustments as described below Adjustment Door adjustment may be accomplished at two places at the hinge straps to door panel and at the hinge cage to pillar fig 10 84a Before adjustment is made on any door however the striker plates should be loosened and adjusted after door is located The door can be moved up and down at the hinge pillar A fig 10 84a and the door can be moved in and out at the hinge to door panel B fig 10 84a Move door as required and tighten bolts Install plastic plugs in all hinge bolt access holes fig 10 84a Normal surface of door outer panels and body outer panels must align from flush to 060 of being flush The doors should be flush or within r of being flush at the vertical lip of the door fig 10 85a There should be 3 16 at the top and sides of each door There should be 1 4 clearance between the vertical center and bottom with both doors closed