e v i Fig 10 75a Rear Doors 95 Position w v T Fig 10 76a Hinge Position Fully Open REAR DOOR LOCK The rear left door lock is equipped with an inside door handle which is squeezed in the direction of pull to open the door fig 10 77a Lock rods extend from the lock which is supported in a bracket welded within the door at one end and supported on the other end with an outer plate fig 10 80a The lock rods are adjustable to allow for wear in the upper and lower catches 2 figs 10 80a and 10 81a RIGHT REAR DOOR HANDLE AND LOCK ASSEMBLY Removal and Installation Refer to Figure 10 78a 1 Remove plastic plug from door inner panel for s Fig 10 77a Rear Left Door lock access to door handle outer retainer screw fig 10 78a 2 Remove handle retaining screw at door edge and remove handle and lock cylinder assembly 3 Install rear and front gaskets between handle and door panel 4 Install handle and lock assembly retaining screws one at the door edge and the other through the door inner panel 5 Replace plastic plug in door inner panel LOCK CYLINDER REPLACEMENT Refer to Figure 10 78a 1 Remove outside door handle assembly 2 Remove the lock retaining snap ring Lockwire then remove stop washer spring and spring seat noting relative positions of the stop washer and spring seat 3 Remove the lock cylinder and push button shaft assembly 4 Remove the handle sealing ring 6 fig 10 78a 5 If necessary the lock cylinder lock cylinder housing and push button shaft may be disassembled as follows a Bend the ears of the push button cap sufficiently to disengage cap from cylinder housing Disassemble cap cylinder housing and lock cylinder Figure 10 54a shows the lock disassembled b Repair or replace the lock cylinder c Assemble lock cylinder into housing and re place the push button cap rebending ears to original position