located at the door edge for removal of retainer ring 4 Remove handle NOTE While handle is removed the escutcheon and gasket can be removed 5 Install gasket and escutcheon to door panel with retaining screws fig 10 67a 6 Install handle and rubber bumper assembly to door and snap retainer ring 1 fig 10 67a in place through access hole or trim panel opening s e a O Fig 10 68a Side Door inter Lock Access Cover SIDE INTERMEDIATE DOOR LOCK CYLINDER Removal and Installation 1 Remove trim panel on doors equipped with windows and on panel doors remove access cover fig 10 68a 2 Reach behind lock and pull lock cylinder retainer from lock cylinder fig 10 69a 3 To install reverse the removal procedure SIDE INTERMEDIATE DOOR REMOTE CONTROL Removal 1 On panel door models remove access cover shown in Figure 10 68a On doors with windows remove trim panel retaining screws fig 10 64a and remove trim panel 2 Remove remote control handle set screw 18 fig 10 70a and remove remote control handle and gasket washer 3 Remove three remote control retaining screws fig t SNAP RING I ie f T t Kt 7AINER LOCK CYLINDER Fig 10 69a Side Intermediate Handle and Lock Cylinder Retainer 10 64a while holding plate and nut assembly fig 10 72a NOTE On panel models reach through access hole and unhook remote control arm from lock actuating arm fig 10 71a On models with windows reach through trim panel opening and remove remote control arm from lock actuating arm 4 Remove remote control assembly Installation NOTE Work through trim panel on models equipped with windows or through access hole on panel doors 1 Hook remote control arm on lock actuating arm fig 10 71a NOTE Be sure anti rattle spring washer flg 10 71a is in place 2 Install remote control assembly mounting screws fig 10 64a while holding plate nut assembly behind control NOTE Insert corner screw to plate assembly then rotate plate assembly into place and install remaining screws 3 Install control handle and gasket Lock handle in position with set screw