i i Fig 10 58a Removing Hinge Pins Installation 1 If a hinge has been removed install the hinge in the pillar in approximately the same position as previously installed Assemble grommet to door before inserting hinge in door and bolting 2 Position the door and install the retaining bolts for each door just snug until after making door adjustments as described below Door Clearance Adjustment Door adjustment may be accomplished at two places at the hinge straps to door panel and at the hinge cage to pillar fig 10 60a Before adjustment is made on any door however the striker plates should be loosened and adjusted after door is located The door can be moved in and out at the hinge pillar A fig 10 60a and the door can be moved up and down at the hinge to door panel B fig 10 60a Move door as required and tighten bolts Install plastic plugs in all hinge bolt access holes that are required Normal surface of door outer panels and body outer panels must align from flush to 060 of being flush The doors should be flush or within 3 s of being flush at the vertical lips of the doors fig 10 61a There should be 3 1 R at the top and sides of each door There should be 1 4 clearance between the vertical centers and the bottom with both doors closed r y rt r H F UPPER HINGE BOLT LOCATION i rr 9 PILLAR q Fig 10 59a Side Rear Door Hinge Pillar Interlock Adjustment 1 Loosen bolts A fig 10 56a at upper and lower interlock attached to the side rear door assembly 2 Loosen the upper and lower interlock plates attached to the body fig 10 56a I GROMMET i DOOR 1 I 1 EDGE GROMMET LIT UP soLT I v r r n PLUG BOLT NUT MEW A Fig 10 60a Hinge Adjustment nnwms uAuum