a NOTE Diaphragm and body assembly inIII cludes the fuel diaphragm oil seal and control rod 2 Remove lower body and pulsator diaphragm fron pulsator cover 3 Remove valves from lower body by removinj metal displaced by staking and pulling out valve with hook shaped tool Cleaning and Inspection 1 Clean and rinse all metal parts in solvent Blov out all passages with air hose 2 Inspect all parts for cracks breakage and dis tortion Examine all screw holes for stripped o crossed threads Replace damaged parts Assembly Refer to Figure 9 36 1 Assemble pulsator cover pulsator diaphragn lower body with valves replaced and staked body and diaphragm assembly spring and covei Install bolts and draw up equally until tight NOTE One bolt hole is offset to assure proper positioning of component parts Installation on Engine 1 Install T connector and pipe in pump outlet connection 2 Install the pump into the accessory housinE 2 3 4 Fig 9 76 Pus l Cover 3 Diaphragm and Body Assembly 2 Spring 4 Lower Body 1 i RETURN SPRING PUMP ROD r a Fig 9 35 Removing Push Rod outlet connection to front Carefully feel pump position with set screw being sure set screw pilots in locking hole 3 Tighten set screw 9 to 15 ft lbs Then tighten lock nut 9 to 151bs 4 Install inlet fuel line to inlet connection on fuel pump and outlet lines to the T connector S 6 7 8 O 06 I Pump lzpleded Vi w S Valve Gasket 7 Pulsator Diaphragm 6 Valve 8 Pulsator Cover