i i Fig 1 t IwaMUwnwl hw I R ww0l attaching screws shown in Figure 162 and Pull the cluster from the instrument panel 4 Disconnect the wiring connectors and remove the cluster from the vehicle I I Installation 1 Make sure all instruments and in Automatic Transmission models the control assembly are in place NOTE Move the selector lever to its full DOWN position 2 Install all wiring connectors Carefully insert the cluster into the opening in the instrument panel guiding the two locating pins at the top of the cluster into their holes on the panel and being sure that the clips are behind the instrument panel 3 Install the two cluster retaining screws 4 Install the speedometer cable On Automatic Transmission models install the control cable in the control support assembly and attach the end of the cable to the control assembly with the C clip provided 5 Reconnect the battery ground cable and test operation of all electrical units HORN AND HORN RELAY All Troubles and Remedies covered on the previous pages for Corvair Sedan models also apply to all Corvair 95 and Greenbrier models The horn or horns are installed to the frame side rails with a single bolt nut and lockwasher CORVAIR SHOP MANUAL