1 a I v I a p f o ih O a I 1 Qs W t ffffffW ft s y 1 r Wl rt tt 1 l BULB AND LAMP BODY SERVICE Parking Lamp Remove and install the parking lamp bulb and or housing assembly in the same manner as on the Corvair Sedan models covered previously in this section TAIL STOP AND BACK UP LAMP 1 To replace bulb a Remove the three phillips head screws securing the lens to the housing Remove housing see Figure 8 159 b Remove bulb and install new bulb c Reinstall lens to housing with the three retaining screws 2 To remove the lamp housing assembly a Remove the three lens attaching screws b Remove the two hex head screws which secure the housing c Pull housing straight out and disconnect the electrical connector d Reverse the procedure to reinstall the housing AND GAUGES s i U Fig 8 161 Autornatic Transmission Control Installation 2 Automatic Transmission models only See Figure 8 161 Remove the C clip attaching the transmission cable assembly to the transmission control assembly Remove the nut attaching the cable assembly to the control support arm Move the selector lever to LOW position 3 Remove speedometer cable and the two cluster CORVAIR NO MANUAL