Tow Me 7 I id w 10 f v Iw ae l MOM t r w Fig 6E 55 Measuring Front Pump Bolt Torque 15 Install front pump drive shaft fig 6E 53 Use care when inserting pump shaft not to damage bushings of transmission components already installed 16 Install a new square cut seal ring in front pump cover fig 6E 54 then position front pump cover dip bolt heads in oil impervious sealer such as used on Turboglide front pump bolts and install mounting bolts loosely Tighten outer bolts in a criss cross pattern to 18 20 ft lbs torque then tighten five inner bolts to same torque fig 6E 55 By using this sequence the chance of cocking the front pump which would bind the pump hub to the front pump shaft is virtually eliminated 17 Adjust the low band by first tightening the adjusting screw to 40 5 inch lbs then back off four 4 full turns exactly Hold the adjusting screw and lock the adjustment by fully tightening the lock nut If assembly of transmission has been performed with the transmission separated in the Power Train it will be necessary to determine the thickness required in selective spacers to be installed at the governor gear location prior to reassembly of the transmission to the differential carrier This procedure is provided earlier in this manual in Section 6 Power Train where the instructions for assembly of the Powerglide to the rear axle are provided